10BASE-T

RJ-45

Category 3, 4, or 5 unshielded twisted pairs (UTP)

100m (328 ft)

100/1000BASE-T1

RJ-45

Category 52 UTP

100m (328 ft)

11000BASE-T signaling requires 4 twisted pairs of Category 5 balanced cabling, as specified in ISO/IEC 11801:1995 and ANSI/EIA/TIA-568-A (1995) and tested for additional performance using testing procedures defined in TIA/EIA TSB95.

2Category 5 is the minimum requirement. Category 5e and Category 6 are fully supported.

PCI Clock

66 MHz maximum

PCI-X Clock

133 MHz

PCI/PCI-X Data/Address

32-bit and 64-bit

PCI-X Data Burst Transfer Rate

400 Mbit/s (32-bit bus at 100 MHz)
800 Mbit/s (64-bit bus at 100 MHz)
600 Mbit/s (32-bit bus at 100 MHz) - BCM5701/BCM5703 only
1024 Mbit/s (64-bit bus at 100 MHz) - BCM5701/BCM5703 only

PCI Data Burst Transfer Rate

132 Mbit/s (32-bit bus)
264 Mbit/s (64-bit bus)
528 Mbit/s (64-bit bus at 66 MHz)

PCI Modes

Master/slave

PCI Express Interface

x1 link width

PCI Express Aggregated Bandwidth (Transmit and receive)

2.5 Gbps

10/100/1000BASE-T

10/100/1000 Mbps (full-duplex)

Temperature

0°C to 55°C (+32°F to +131°F)

–40°C to +85°C (–40°F to +185°F)

Relative humidity

5% to 85% (non-condensing)
40°C, 16 hour dwells at extremes

5% to 95% (non-condensing)
10°C/hour

Altitude

Up to 10,000 ft.

Up to 35,000 ft.

Shock

10g, 1/2 sine wave, 11 msec

60g, 1/2 sine wave, 11 msec

Vibration, peak to peak displacement

0.005 in. max (5 Hz to 32 Hz)

0.1 in. max (5 Hz to 17 Hz)

Vibration, peak acceleration

0.25g (5 Hz to 500 Hz)
(Sweep Rate = 1 octave/min.)

0.25g (5 Hz to 500 Hz)
(Sweep Rate = 1 octave/min.)